Celestron Compustar Manuál s instrukcemi stáhnout pdf (Strana 19)

modular jacks on the opposite ends of the cable. There are two ways the modular jacks can be

connected if the ribbon of cable is out laid out flat, (which can be a little difficult with a coiled

cable, but one can keep track of which side is which from one end to the other.). One way is with

the retaining clips on the same side of the cable, the other is with the retaining clips on opposite

sides. RJ-11 cables suitable for autoguiding the Compustar have the retaining clips on the

opposite sides (Figure 11).

Figure 11. Orientation of the retaining clips on the modular jacks of an RJ-11 cable

suitable for autoguiding the Compustar. Note, with the cable laid out flat (this is a side

view), the clips are on opposite sides.

The wires of the RJ-11 cable are both numbered and color coded. If you look down on the

copper pins of the modular jack of an RJ-ll cable with the cable toward the left and the modular

jack toward the right (Figure 12), then the wires and their corresponding copper pins are

numbered 1 through 6, with 1 at the top and 6 at the bottom. The wires are color coded and must

be in a particular order. The correct order is wire 1=white, wire 2=black, wire 3=red, wire

4=green, wire 5=yellow, and wire 6=blue.

1 2 ... 14 15 16 17 18 19 20 21 22 23 24 ... 47 48

Žádné komentáře

Celestron Compustar Manuál s instrukcemi Strana 19